Reversible storage of molecular hydrogen by sorption into multilayered TiO2 nanotubes

The sorption of hydrogen between the layers of the multilayered wall of nanotubular TiO2 was studied in the temperature range of -195 to 200 degrees C and at pressures of 0 to 6 bar. Hydrogen can intercalate between layers in the walls of TiO2 nanotubes forming host-guest compounds TiO2 x xH2, where x < or = 1.5 and decreases at higher temperatures. The rate of hydrogen incorporation increases with temperature and the characteristic time for hydrogen sorption in TiO2 nanotubes is several hours at 100 degrees C. The rate of intercalate formation is limited by the diffusion of molecular hydrogen inside the multilayered walls of the TiO2 nanotube. 1H NMR-MAS and XRD data confirm the incorporation of hydrogen between the layers in the walls of TiO2 nanotubes. The nature and possible applications of the observed intercalates are considered.     

Determination of orthophosphates using a macro segmented flow analyzer (MSFA) based on colorimetric detection

Fabrication of a macro segmented flow analysis (MSFA) system based on reconfiguration of the manifold by adjustment of the sample/reagent ratio, has been found to produce a sensitive method for orthophosphate analysis based on colorimetric detection at 880 nm. Optimization of sample tube length, reaction temperature and molybdate concentration in the carrier solutions has been carried out. The larger sample tube internal diameter led to the combined advantages of better sensitivities, wider working range and higher sample throughput over most existing methods. Using the optimized conditions of 50.0 cm sample tube length (1.6 mm i.d.), 37.0 °C reaction temperature and 0.0113 M molybdate concentration in the carrier solution, the calibration model for orthophosphate standard solutions was found to be linear (y = 0.04895x + 0.003561; correlation coefficient, r²=0.9970) over the working range 0.01-2.00 mg l⁻¹ orthophosphate. The volume of the sample injected was 1.396 ml at a flow rate of 6.0 ml min⁻¹. The sample throughput of this MSFA method was 40 samples per an hour, with a detection limit of 4.0 μg l⁻¹, and %R.S.D.’s below 5%. The MSFA method was successfully applied to analysis of water and wastewater samples.     

Synthesis of 5,6-dihydro-4H-thiopyran-4-ones

The anions of 1,4-diaryl-3-buten-2-ones 1 reacts with arylisothiocyanates, yielding intermediates 4 which can ring close to 5,6-dihydro-4H-thiopyran-4-ones 5 . Under similar reaction conditions ethyl 3-oxo-4-pentenoates 7 gives the 6-spiropyrans 9 . Methylation of 3 gives the S-methylated open form 6 .     

Beta-sheet preferences from first principles

The natural amino acids have different preferences of occurring in specific types of secondary protein structure. Simulations are performed on periodic model beta-sheets of 14 different amino acids, at the level of density functional theory, employing the generalized gradient approximation. We find that the statistically observed beta-sheet propensities correlate very well with the calculated binding energies. Analysis of the calculations shows that the beta-sheet propensities are determined by the local flexibility of the individual polypeptide strands.     

Autonomous intelligent agents for accelerated materials discovery

We present an end-to-end computational system for autonomous materials discovery. The system aims for cost-effective optimization in large, high-dimensional search spaces of materials by adopting a sequential, agent-based approach to deciding which experiments to carry out. In choosing next experiments, agents can make use of past knowledge, surrogate models, logic, thermodynamic or other physical constructs, heuristic rules, and different exploration–exploitation strategies. We show a series of examples for (i) how the discovery campaigns for finding materials satisfying a relative stability objective can be simulated to design new agents, and (ii) how those agents can be deployed in real discovery campaigns to control experiments run externally, such as the cloud-based density functional theory simulations in this work. In a sample set of 16 campaigns covering a range of binary and ternary chemistries including metal oxides, phosphides, sulfides and alloys, this autonomous platform found 383 new stable or nearly stable materials with no intervention by the researchers.

We present an end-to-end computational system for autonomous materials discovery.     

The Electronic Structure of Azuleno[1,2,3-cd]phenalene and Azuleno[5,6,7-cd]phenalene,a Comparison

The photoelectron (PE.) spectra of azuleno[l, 2, 3-cd]phenalene ( 1 ) and azuleno- [5,6,7-cd]phenalene( 2 ) have been recorded. The first five bands of both compounds could be assigned to transitions corresponding to removal of electrons from 4a₂, 6b₁, 5b₁, 3a₂ and 4b_l orbitals. This assignment is based mainly on a comparison between the observed ionization potentials and orbital energies calculated in a HMO and a PPP model. The UV./VIS. polarized absorption spectrum of 1 in the region 10000–45000 cm^?1 has been measured by means of the stretched film technique. The measurements were performed in polyethylene sheets at 77°K. Several bands could be assigned to π* ← π transitions calculated by a PPP-CI method. A comparison between the electronic structures of 1 and 2 is made by means of a simple HMO diagram.     

Synthesis of new tropinone derivatives by palladium-catalyzed couplings of 8-azabicyclo[3.2.1]oct-2-enyl nonaflates

Whereas tropinone derived nonaflate 3 was no suitable precursor for Heck-reactions, the related carbamate 7 was an excellent substrate for palladium-catalyzed processes. Nonaflate 7 was either isolated in excellent yield by LDA treatment of ketone 5 followed by trapping with NfF (nonafluorobutanesulfonyl fluoride) or generated in situ by fluoride-catalyzed reaction of silyl enol ether 6 with NfF. The desired 1,3-diene 8 was prepared by conventional Heck-reaction of nonaflate 7 with methyl acrylate in almost quantitative yield. Alternatively, the one-pot nonaflation-Heck protocol starting from silyl enol ether 6 provided 8 in good yield. The couplings of acrylonitrile or phenyl vinyl sulfone were also performed with in situ generated 7 and they afforded the expected 1,3-dienes 9 and 10 in good yields. The Sonogashira-reaction with phenylacetylene also started from silyl enol ether 6 and provided enyne 11 via 7 in good yield. A Diels-Alder reaction of 1,3-diene 8 with N-phenyl maleimide at 100 °C furnished tetracyclic adduct 12 in good yield, with excellent diastereofacial selectivity, but with low endo-exo-selectivity. Nonaflate 14 was easily obtained from the corresponding unsaturated bicyclic ketone 13. It behaved differently in an attempted Heck-reaction and mainly led to fragmentation products 15 and 16, whereas the expected 1,3-diene 17 was formed only as minor component. However, 14 could successfully be used in a Sonogashira-reaction with phenylacetylene to afford compound 18. These transformations demonstrate the great potential of tropinone derived alkenyl nonaflates for diversity oriented syntheses of interesting compounds containing an 8-azabicyclo[3.2.1]octane scaffold.     

Neue Kupferkomplexe mit Phosphaalkenliganden. Molekülstruktur von [Cu{P(Mes*)C(NMe2)2}2]BF4 (Mes* = 2,4,6‐tBu3C6H2)

New Copper Complexes Containing Phosphaalkene Ligands. Molecular Structure of [Cu{P(Mes*)C(NMe₂)₂}₂]BF₄ (Mes* = 2,4,6‐tBu₃C₆H₂) Reaction of equimolar amounts of the inversely polarized phosphaalkene tBuP=C(NMe₂)₂ ( 1a ) and copper(I) bromide or copper(I) iodide, respectively, affords complexes [Cu₃X₃{μ‐P(tBu)C(NMe₂)₂}₃] ( 2 ) (X =Br) and ( 3 ) (X = I) as the formal result of the cyclotrimerization of a 1:1‐adduct. Treatment of 1a with [Cu(L)Cl] (L = PiPr₃; SbiPr₃) leads to the formation of compounds [CuCl(L){P(tBu)C(NMe₂)₂}] ( 4a ) (L = PiPr₃) and ( 4b ) (L = SbiPr₃), respectively. Reaction of [(MeCN)₄Cu]BF₄ with two equivalents of PhP=C(NMe₂)₂ ( 1b ) yields complex [Cu{P(Ph)C(NMe₂)₂}₂]BF₄ ( 5b ). Similarly, compounds [Cu{P(Aryl)C(NMe₂)₂}₂]BF₄ ( 5c (Aryl = Mes and 5d (Aryl = Mes*)) are obtained from ArylP=C(NMe₂)₂ ( 1c : Aryl = Mes; 1d : Mes*) and [(MeCN)₄Cu]BF₄ in the presence of SbiPr₃. Complexes 2 , 3 , 4a , 4b , and 5b‐5d are characterized by means of elemental analyses and spectroscopy (¹H‐, ¹³C{¹H}‐, ³¹P{¹H}‐NMR). The molecular structure of 5d is determined by X‐ray diffraction analysis.     

On Excited States of Alkyl Bridged [14] Annulenes

The linear dichroic absorption spectrum of 1,3,6,8-trans-15, 16-hexamethyl-dihydropyrene has been measured in stretched polyethylene at 77K, and CNDO-CI calculations with inclusion of singly and doubly excited configurations have been carried out on a series of alkyl bridged [14] annulenes with pyrene- and anthracene-shaped perimeters. Transitions to e_3g → e_4u type ¹B states are well described, and the results indicate that additional low-energy excited states originate from e_3g→ e_5g and e_2u → e_4u type configurations interacting strongly with doubly excited configurations of the e_3g, e_3g → e_4u, e_4u type. The second excited singlet state responsible for the weak transition observed between the ¹L bands may be assigned to one of these additional states, but it is probably of complex nature, similar to the ‘phantom’ state in linear polyenes.